Engine Repair

Five Car Problems That Can Cause You to Need Major Engine Repair

Unfortunately, too many Yadkinville car owners tend to put maintenance on the back burner. This neglectful attitude leads to some components failing sooner than expected, including the engine. Here are five of the biggest problems that can cause you to need major engine repair.

Overheating Issues
When your temperature needle begins to approach the red zone, be sure to pull over as soon as possible. Overheating can cause catastrophic engine damage. From the pistons to the head gasket, a number of parts can be destroyed. You’ll ultimately need to take the vehicle to an engine repair expert.

Engine overheating can stem from a number of different issues. However, a lack of coolant tends to be the biggest culprit. Like old coolant hoses, a damaged radiator can spring a leak at any given time.

Improper Lubrication
It’s important to have your oil changed at the recommended intervals. If you fail to do so, there’s a greater chance you’ll need major engine repair. Improper lubrication causes the various moving parts to experience premature wear and tear.

It’s even more dangerous to drive with a low level of oil. It’s only a matter of time before an oil-starved completely locks up. The cost to repair the damage can be thousands of dollars. To be on the safe side, develop a habit of checking your oil level every two weeks. This is especially true if you tend to spend a lot of time on the road.

Misfiring
A misfiring engine should never be taken lightly. It does more than just cause your vehicle to run poorly. When misfiring occurs, this can cause excessive heat and pressure to develop inside the combustion chamber. If your vehicle’s check engine light suddenly begins to flash repeatedly, the best approach is to call for a tow.

With the use of advanced diagnostic equipment, an engine repair shop can track down the root of the problem. In many instances, the misfiring can be resolved by installing a new set of spark plugs and ignition wires.

Hydro locking
Hydro locking occurs when too much water gets inside the engine. This issue is more likely to happen to drivers who attempt to cross a flooded street. Within seconds, the engine can absorb several liters of water at once. Vehicles with a low ground clearance must be especially careful.

The pistons are not designed to compress water. When accelerating hard, the shafts and valves could break. Even worse, holes can be blown through the engine block. Major engine repair will be required.

Broken Timing Belt
If you own an older import car, there’s a good chance it’s equipped with a timing belt. This part typically must be changed every 60,000 to 100,000 miles. The recommended replacement interval can vary from one model to the next.

A broken timing belt can cause an extensive amount of engine damage. This is certainly true for vehicles that feature an interference engine. Before buying a used car, always have the timing belt inspected by a professional automotive mechanic.

 

Leave a comment

Your email address will not be published.

Yadkinville Auto